 |
Frequently Answered Questions
- Does the high crank position cause numb feet?
- Numbness at the ball of the foot is usually caused by pressure of the
pedal on the ball of the foot. This is independent of the relative height
of the crankset to the seat. Riders that experience this problem should
try the following:
- Use clipless pedals and biking shoes with stiff soles.
- Make sure your shoes are not too tight in the ball of the foot.
Try lacing them a little looser.
- Shift down to a lower gear and work on spinning. During the
spinning stroke you should actually be pulling down and backwards for a
short time. This helps to reduce the constant pressure on the ball of the
foot that causes the burning sensation.
[Top of Page]
- How do I carry water bottles?
-
First, we're big fans of seat bags and hydration bladders and would
recommend them to every recumbent rider. It's easier to drink from, which
means you'll stay more hydrated; you don't have to take your eyes off the
road or tip your head back to drink, which means you'll stay in control;
and you'll never see your bladder go skidding down the road after you hit
a big pothole.
For those of you still not convinced, we've found several
mounting options for water bottle users:
- FastBack Bottle System on the seat.
- Minoura Bottle Cage Mounts on the chainstays.
- M5 Cage Mounting Kit on the seat.
Any of these will work great for just carrying extra water, but we
recommend the Minoura chainstay mounting option for primary use since it's
much easier to grab and replace a bottle than seat-mounted options, it's
inexpensive, there are no cumbersome straps, it's quite secure, and it
requires no drilling to your hardshell seat. Click Here to see bottles mounted in
this fashion.
[Top of Page]
- Is the Volae Monotube frame efficient?
- In the diamond frame bike world, efficiency in transferring energy
from the rider to the rear wheel is commonly referred to as frame
efficiency. Movement at the bottom bracket is the telltale sign of an
inefficient frame. However, this diamond frame logic does not transfer perfectly to
the recumbent frame situation. In the recumbent world frame efficiency
(determined by movement of the bottom bracket) is only part of the
equation. In fact, the definition of "frame" itself is somewhat blurred
compared to upright bikes. On a recumbent (unlike an upright) the seat,
seat attachment hardware and seat stays all provide a platform for the
rider to push against when pedaling. Does this make them part of the
frame? Also, chain management is a recumbent specific issue not found on
uprights that affects the efficient transfer of energy but is clearly not
part of the frame.
At Volae we think of the Energy Transmission System (ETS) as a more
comprehensive means for analyzing energy transmission from the rider to
the rear wheel. The ETS includes the frame design, frame material, tubing
specifications, seat stay design & material, seat attachment hardware, the
seat itself and the chain management. All of the above effect energy
transmission from the rider to the rear wheel. Everyone is aware that
efficiency is compromised if the boom allows the bottom bracket to move
excessively from side to side. However, efficiency is also compromised if
the rear triangle design allows the seat to move from side to side when
pedaling or if there is friction in the chain management system. Focusing
on one of the ETS components at the exclusion of the others may lead to
inaccurate conclusions. The Volae design evolved from an awareness of the
role that all of the ETS components play in making an efficient bike.
Volae frames are designed to allow enough vertical flex to absorb road
shock and provide a smooth ride while minimizing side to side flex at the
boom and rear triangle. The result is a perfect combination of comfort and
efficiency. The only people that think our recumbents aren't efficient
haven't ever ridden one.
[Top of Page]
- Where did the "Volae" name come from?
- Developing our company name was a difficult task, which took many
hours of brainstorming over a three-month period. We had planned to
develop a "manufactured name" that was not a foreign name, since our bikes
will be made in USA. During a brain storming session with my son Ben and a
consultant (Kevin), I suggested Rolet. It came to mind while driving
behind a Chevrolet pickup truck. However, we felt it might be
mispronounced. Ben suggested replacing the "et" with "ae" resulting in
Rolae. Then, since we were also considering some names beginning with "V",
Ben suggested changing the "R" to a "V". The result was Volae. We all
liked the sound of it immediately.
[Top of Page]
- Will a fairing make me even faster on my Volae?
- The real question with fairings is, "Does the wind close behind the
fairing before it reaches the rider?" At the bicycling speeds found on a
dual 650 recumbent with a laid-back body position and high bottom bracket,
the rider is too far behind the fairing to get much of a "drafting" effect
from it. This is especially true when riding in cross winds or quartering
into the wind. A fairing will improve your aerodynamics on a 26/20 model
with an upright seating position and a mesh seat. However, a fairing
alone will probably not provide much of a speed advantage on a dual 650 or
dual 26" model with a molded seat and a laid back seating position.
But, will fairings help keep your feet warm and extend your riding
season? Yes!!!
[Top of Page]
- What about chain line noise?
- The vast majority of Volae riders don't have any concerns about chain
line noise. However, on occasion, a rider does complain about "idler
noise." We researched this issue and found that while some noise comes
from the idlers, the bulk of the chain line noise comes from the chain
passing through the jockey wheels on the rear derailleur, the
chain/cassette interface, and the rest of the drivetrain.
Our seat stay design may be the culprit and also the hero. Force is
applied to the pedals by pressing your back against the seat. Seat stays
that allow the seat to move from side to side absorb energy and,
incidentally don't transmit sound very efficiently. Volae seat stays
provide an extremely solid platform to push from (the hero part) but also
do an excellent job of transmitting sound (the culprit part) to the hollow
channels of the molded seat and the rider's ears. Tap the rear derailleur
of a Volae with the handle of a screwdriver. The resulting sound seems to
come from the vicinity of the seat and the rear idler.
Is a Volae drivetrain louder than some others? ...Sure.
Is it more efficient, smoother and more durable? ...Definitely!
[Top of Page]
- How does the speed of a Volae compare to speed of an upright?
- Volae positions the rider in a naturally aerodynamic tuck position.
Most riders cannot stay in the aerodynamic tuck position on conventional
bike for more than a mile or two without discomfort, while a "recumbent
tuck" is completely comfortable and is the position you always ride in.
All the human powered speed records including the DuPont Prize for
breaking 65mph are held by recumbents. (Francis Faure set speed records
for the mile and kilometer in 1933 on a recumbent. The Union Cycliste
Internationale (U.C.I.) promptly banned recumbents from racing because
they felt recumbents provided an unfair aerodynamic advantage. As a
result, recumbents have not been used since in racing and have not been
mass-produced until recently.)
Speed is largely dependent on the engine (you), but our own experiences have
shown a significant advantage over upright bikes in flat and rolling terrain, and no real
advantage to either in moderate hills. In very steep hills, an upright rider can have
an advantage due to their ability to stand on the pedals and muscle up steep inclines.
[Top of Page]
- Is there a Volae newsgroup I can subscribe to?
- Yes! It's a gathering place for owners and potential owners of the
Volae line of recumbent bicycles. A forum for exchange of information on
equipment, rides, and anything relating to the Volae line in general.
Visit http://groups.yahoo.com/group/Volae_Recumbents/ to
browse or subscribe.
[Top of Page]
|
 |
Just wanted to say thank you for a very nice product
and very nice service. I purchased the Alpha Q EX carbon fork for my
Volae Club. It went on fine and the service I received from your sales,
shipping and mechanics was unmatched by anything I have available around
here. Thanks a lot, see you at the Rally. |
|
|
